ProPoint
TM
Outdoor Luminaire Small Cobrahead (SC)
Installation Guide
Riskoffireorelectricalshock.Installthis
moduleonlyintheluminaires thathavethe
constructionfeaturesanddimensionsshownin
thephotographsand/ordrawings
Donotmakeoralteranyopenholesinan
enclosureorwiringorelectricalcomponents
duringmodulesinstallation
Toensurepersonalsafety,
propergroundingis
required
Lightenginemoduleinstallationrequires
knowledgeofluminaireelectricalsystems.Ifnot
qualified,donotattemptinstallation.Contacta
qualifiedelectrician
Topreventwiringdamageorabrasion,donot
exposewiringtoedgesofsheetmetalorother
sharpobjects
Cobrahead Fixture available in 55, 80,
100 and 120 Watts, mounts easily on a
1 ¼” NPS or 2” NPS arm
www.sylvania.com
Safet
Warnin
s:
Luminaire Installation:
Open the luminaire by pulling the trigger latch toward the nose of the fixture.
Swing the lower housing (door) away from the upper housing. Disconnect
wiring harness plug. When the lower housing is opened to 135 degree, the
lower housing can be removed from its hinges for easier installation of
upper housing.
Determine the size of the mast arm. This luminaire is designed
to optimally accommodate a 1-1/4”-2” mast arm. Tighten
mounting bolts 10-15 ft-lbs.
Trigger Latch
SC Upper Housing PEC Receptacle
Hinge
SC Lower Housing (door)
Lens
/Reflector
Mast Arm
Fitter Clamp
Fitter Bolt
Leveling Steps
SC U
er Housin
with Lower Removed
Loosen the two fitter bolts in the upper housing. Lift the upper
housing into position in front of the mast arm so that the mast
arm enters opening at the rear of the housing and extends into
the fixture between the fitter clap and the luminaire leveling
steps. Using the cast leveling steps, adjust the luminaire to the
desired mounting angle. Fully tighten fitter clamp bolts (10-15 ft-
lbs).
Mast Arm Opening
LED178
Commenti su questo manuale